Elevated Temperature Primary Load Design Method Using Pseudo Elastic-Perfectly Plastic Model

Carter, P., Sham, T.L., Jetter, R.I.


ABSTRACT:

A new primary load design method for elevated temperature service has been developed. Codification of the procedure in an ASME Boiler and Pressure Vessel Code, Section III Code Case is being pursued. The proposed primary load design method is intended to provide the same margins on creep rupture, yielding and creep deformation for a component or structure that are implicit in the allowable stress data. It provides a methodology that does not require stress classification and is also applicable to a full range of temperature above and below the creep regime. Use of elastic-perfectly plastic analysis based on allowable stress with corrections for constraint, steady state stress and creep ductility is described. This approach is intended to ensure that traditional primary stresses are the basis for design, taking into account ductility limits to stress re-distribution and multiaxial rupture criteria.

 

P. Carter, T.L. Sham and R.I. Jetter, “Elevated Temperature Primary Load Design Method Using Pseudo Elastic-Perfectly Plastic Model”, Proceedings of ASME 2012 Pressure Vessels & Piping Conference, PVP2012-78081, Toronto, 2012.