Defect Characterization and Assessment

With the use of new in-line inspection (ILI) tools, detailed geometrical information for a dent can now be obtained without excavating the pipeline. In addition, widely available general-purpose finite element software and increased processing power have reduced analysis times...

read More....
0
17
May 2021

Testing Services

Lorem ipsum dolor sit amet, consectetur adipisicing elit, sed do eiusmod tempor incididunt ut labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco laboris nisi ut aliquip ex ea commodo consequat. Duis aute irure dolor in reprehenderit in voluptate...

read More....
0
17
May 2021

Rod Load Measurement (RLM)

In-Place Measurement of Pipe Hangers and Piping Loads Without interrupting your operation, we can measure spring support and rigid rod loads to ensure your pipes, headers, and equipment are being supported as designed. Do You Have: Bottomed-out spring hangers? Sagging...

read More....
0
17
May 2021

Finite Element Analysis

Complicated systems and structures don’t always have to require complicated analysis to determine fitness-for-service (FFS) or damages.  FEA is a routinely utilized methodology that can save operators time and is often more economically advantageous. This method is more efficient...

read More....
0
17
May 2021
17
May 2021

Equipment Vibration Monitoring

Field Vibration Surveys – Portable Data Acquisition Most field vibration troubleshooting starts with basic data collection via portable, hand-held signal analyzers that are easily moved around multiple locations in the vicinity of a vibration problem. Even complicated...

read More....
0
17
May 2021
Close

Contact Us

If you would like more information on Stress Engineering Services, please call us at 281.955.2900, or complete the following form and one of our representatives contact you shortly. For a complete listing of contact information, visit our Locations page.

"*" indicates required fields

This field is for validation purposes and should be left unchanged.